Maintaining and Servicing the CN SignalMaster™
19
Installation, Maintenance, and Service Manual
Federal Signal
www.fedsig.com
Replacing a Reflector
CRAZING HAZARD: Crazed, cracked, or faded domes or reflectors reduce the
light output and the effectiveness of the lighting system. Tops or reflectors
showing this type of aging must be replaced. Failure to follow this warning
may result in bodily injury or death to you or others.
To replace a reflector:
1.
To remove the PCB that holds the reflector, see “Replacing a PCB” on page 16.
2.
Use a small Phillips screwdriver to press and release the two round tabs on the
reflector from beneath the PCB. Slide the reflector toward the rear of the PCB. See
Figure 7.
3.
Lift the rear of the reflector away from the PCB and remove it.
4.
To install the new reflector, insert its front hooks into their slots on the PCB.
5.
Bring the rear of the reflector down to insert its rear hooks through the PCB.
6.
When the reflector rests on the PCB, make sure the rear hooks are fully inserted
and slide the reflector forward until its tabs snap into place.
Figure 7
Removing a reflector
➀
➁
290A6978
➂
➃
PRESS THE ROUND TABS FROM
BENEATH THE PCB AND SLIDE
THE REFLECTOR BACK.
LIFT THE REAR OF THE
REFLECTOR TO REMOVE IT.
➀
➁
REMOVAL:
➄
INSERT THE FRONT HOOKS IN
THE PCB.
BRING THE REAR OF THE REFLECTOR
DOWN ON THE PCB AND INSERT THE
REAR HOOKS INTO THE PCB.
SLIDE THE REFECTOR FOWARD
UNTIL IT SNAPS INTO PLACE.
➂
➃
INSTALLATION:
➄
REAR HOOKS
Getting Technical Support and Service
For technical support and service, please contact:
Federal Signal Corporation
Service Department
Public Safety Systems
Phone: 1-800-433-9132
Email: [email protected]
