Federal Signal Corporation 660100, Installation And Maintenance Manual

Page: 41 / 52

Chapter 6: Setting Control Pad Options
41
PA300-CN Siren Amplifier
Figure 6.3 LED programming indicators on the control pad
REAR
CUT
MAN A/H
LRCO WARN
STBY RADIO PA WAIL PRTY
LEFT
ALLEY
RIGHT
ALLEY
TAKE
DOWN
YELP
CORNER HAZARD
TRUNK
GUN
LOCK
SLIDE SWITCH LEDs: LEDs above the slide switch
glow when the system is on (1=green, 2=amber, 3=red).
The LED brightens above the position in which the slide
switch is placed.
Amber LEDs: The eight LEDs mimic these
active SignalMaster patterns: Left, Right, Center-
Out, or Warn patterns 1 to 4. They also indicate
when a programmed feature of the key pad is
active (see “Setting Control Pad Options” on
page 38.)
Red Button LEDs: All buttons on the
control pad glow when the system is
on. Pressed buttons blink to indicate
that the function they control is active.
The control pad legends in the illustration are for a typical configuration. The PA300-CN siren amplifier system
includes additional legends. All buttons are programmable. For instructions for programming the control pad,
see the "Control Pad Software Configuration Manual” (doc. no. 2562620).
Figure 6.2 Default configuration for steering wheel switches wired to control pad
1
2
AUX
3
4
AUX
SLIDE SWITCH 1
SLIDE SWITCH 2
SLIDE SWITCH 3
BUTTON 2