Room Air Conditioner
1
WARNING
•
Do not
remove or modify this plug
•
Do not
use as an on/off switch
•
Do not
use outdoors
•
Do not
push furniture against or place furniture on the
electrical cord. This can trip the test switch and/or damage
the cord and become a potential condition for arcing
•
Do not
attempt to repair the cord. If the cord requires
replacement, call an authorized servicer.
• The Arc Detection Device is not a Ground Fault
Interrupter and should not be used as such
• The Arc Detection Device contains an electronic circuit
board and should not be submerged or exposed to water
spray
Resetting
If the Arc Detection Device has tripped, the reset button
will pop up.
Follow these steps to reset the Arc Detection Device:
1. Unplug unit from electrical outlet
2. Press the reset button
3. Plug the unit back into electrical outlet
4. Check to see if power has returned to the unit
Testing
You should test the Arc Detection Device equipped power
cord monthly, after every major electrical storm, or if power
to your Room Air Conditioner has been interrupted.
Follow these steps to test the Arc Detection Device:
1. Unplug unit from electrical outlet
2. Press the reset button
3. Plug the unit back into electrical outlet
4. Press test button.
Unit should trip and reset button will pop up.
5. Press reset button again for use
If above test fails, stop using the air conditioner and
contact customer service by calling the following toll-
free number:
1-800-332-6658
or email: [email protected]
WARNING
WARNING
Power Cord with Arc Detection Device
The power cord supplied with this air conditioner is
equipped with an Arc Detection Device designed to shut
off power to the unit when it senses an arc fault condition.
An arc fault is an unintentional electrical discharge that
occurs when electrical products or wires are damaged,
aged, or improperly used. An arc fault can be potentially
hazardous if left undetected.
Electrical Shock Hazard
•
Plug unit only into a grounded electrical
outlet.
•
Do not use an extension cord or plug adapter with this
unit.
•
Do not operate unit with decorative front or filter
removed.
•
Failure to follow these precautions could result in
electrical shock, fire or personal injury.
•
If the air conditioner has a serial plate rating of 115 volts
and greater than 7.5 amps, it must have its own fuse or
circuit breaker, and no other device or unit should be
operated on that fuse or circuit breaker.
•
If the air conditioner has a serial plate rating of 230
volts, it must have its own fuse or circuit breaker, and no
other device or unit should be operated on that fuse or
circuit breaker.
•
We recommend that a qualified electrician install unit in
accordance with the National Electrical Code and local
codes and ordinances.
•
Use copper conductors of correct wire gauge and
protector size only.
•
Do not alter cord or plug end. Do not remove warning
label on cord.
Important Grounding Requirements
•
Air conditioner has a three-prong grounding plug on the
power supply cord, which must be plugged into a
properly grounded three-prong wall receptacle for your
protection against possible shock hazard. For models up
to and including 7.5 amperes, use a grounding type wall
receptacle to match the cord plug.
•
For models above 7.5 amperes use a single outlet
grounding type wall receptacle to match the cord plug.
Do not operate this air conditioner without proper time
delay circuit protection (circuit breaker or fuse). Refer to
serial plate for proper power supply requirements.
Recommended Wire Sizes
(As installed per building code) :
PROTECTOR SIZEWIRE
GAUGE
15 AMP #14 MINIMUM
20 AMP #12 MINIMUM
30 AMP #10 MINIMUM
250V
30A
250V
15A
125V
15A
250V
20A
