Fedders AC1A024A Installation, Operation And Maintenance Manual Download Page 1

1

1

Installation, Operation and Maintenance

Cased Evaporator Coils

Upflow/Downflow

RECOGNIZE SAFETY SYMBOLS, WORDS AND LABELS ................2

NOTES TO INSTALLER ....................................................................2

INTRODUCTION ..............................................................................3

INSPECTION AND UNPACKING ......................................................3

INSTALLATION

Codes..................................................................................2
Installation of Evaporator Coils........................................3
Connect Refrigerant Piping ..............................................3
Factory and Field Installed Expansion Valves ..................3
Condensate Drain Plumbing ............................................4

Heater Exchange Clearance..............................................4

CHECK AND ADJUST AIRFLOW  ....................................................5

Static Pressure Drop Chart ................................................5

Adjusting Airflow ..............................................................5

COIL NOMENCLATURE ..................................................................6

SPECIFICATIONS..............................................................................6

DIMENSIONS ..................................................................................6

WARRANTY ....................................................................................7

NOTE: 

THESE INSTRUCTIONS ARE INTENDED AS AN AID TO QUALIFIED
SERVICE PERSONNEL FOR PROPER INSTALLATION, ADJUSTMENT
AND OPERATION OF THIS EQUIPMENT. READ THE ENTIRE
INSTRUCTION MANUAL THOROUGHLY BEFORE ATTEMPTING
INSTALLATION OR OPERATION.

TABLE OF CONTENTS

 

Summary of Contents for AC1A024A









Reviews: