PAGE 8 OF 11
Glass Information:
1.
Under no circumstances should this product be operated with broken glass.
2. Do not strike or slam the glass.
3. Do not use abrasive cleaners to clean the glass.
4. This product uses tempered glass. Replacement of the glass supplied by the manufacturer should be done by
a qualified service person.
Light Bulb Inspection and Replace:
1.
The flame effect is created by two 40-Watt light bulbs with an E-12 (small) socket base. Use only this type of
light bulb. If the flame effect does not work, the bulbs may have come loose or been damaged during
shipping.
2. CAUTION: Light bulbs become very hot during use. Allow at least 10 minutes for the bulbs to cool before
touching.
3. To inspect or replace the bulbs, first unplug the power cord from the outlet. Locate the access panel on the
back of the stove. Remove the screws and the panel. Check the bulbs to be sure they are finger tight and in
working order. Replace any damaged or faulty bulbs. Reattach the access panel. Do not operate this heater
without the access panel in place. Do not remove the back cover of this heater. There are no serviceable
parts inside.
4. WARNING: Do not exceed 40 watts per bulb. Use of higher rated bulbs may result in a fire, causing property
damage or personal injury.
Motor Maintenance:
Always disconnect the appliance from the main power supply and allow it to cool before any servicing operation.
The motors used on the fan heater and flame blower are pre-lubricated for extended bearing life and require no
further lubrication. However, periodic cleaning/vacuuming of the appliance around the air intake and exhaust, as
well as the fan heater is recommended. For heavy or continuous use, periodic cleaning must be done more
frequently. If the heater blows alternating cold and warm air, check the fan for free movement and for debris
restricting air flow. If the fan does not move freely, the unit must be turned off and the fan replaced immediately in
order to prevent further damage to the unit.
Do not strike or slam the glass.
Care & Cleaning
Always turn the stove OFF and unplug the power cord from the outlet before cleaning. Use a vacuum or
duster to remove dust and dirt from the heater and vent areas. To maintain the finish, clean with a soft,
slightly damp cloth and buff with a dry cloth. Never use abrasive cleansers, liquid sprays, or any cleaner
that could scratch the surface.
WARNING: Before attempting to perform any maintenance on this appliance, turn all controls to the “OFF”
position and then unplug. Allow the appliance to be “OFF” for at least 10 minutes before performing any
maintenance in order to allow all components to cool properly.
MAINTENANCE
ITEM#810469828
SKU#F19-C-041-138
