FLY-DREAM 11 WWW.FD-RC.COM
This means that for model number 1 the timer is set for 1 minute. Press UP or DOWN to change
the timer setting. Press ENTER to change the model number.
After timers are set, press EXIT to save the settings and return to the Special Features menu.
To use the timer, put the Timer Switch in the DOWN position. The screen will show:
Raise the throttle stick to start the timer. Returning the throttle stick to idle pauses the timer. The
timer will count up until the set value is reached, when the buzzer will begin slow beeping. To
stop the beeping and reset the timer, place the Timer Switch in the UP position.
5.2 Transmitter Power
For the Transmitter Power screen, press EXIT. This will display the current setting value. The
F6TB transmitter can be set to a power value of 20dBm, 17dBm, 14dBm, 10dBm, or 0dBm.
Maximum power is 20dBm. Press UP or DOWN to change the power value.
After power is set, press ENTER to save the setting and return to the interface.
To check operation of the system, set power to 0dBm and conduct a range test. Range at
20dBm will be approximately ten times that measured at 0dBm.
6 Stick Mode and Country Selection
Press ENTER and EXIT at the same time and turn on the transmitter. There is now a choice
between the Stick Mode screen and the Country screen, as follows:
Press EXIT
for Country
Press ENTER
for Stick Mode
Press UP or DOWN
