L I G H T I N G I N S T R U C T I O N S
LIGHTING INSTRUCTIONS
1.
The lid must be open when lighting the burner. Do not stand with your face directly over the gas
grill when lighting it. Your gas grill will have following method of ignition: PILOT GAS CONTROL
IGNITION
2.
With all gas controls on the gas grill in the “OFF” position, turn the gas cylinder valve to the ON
position at the regulator.
3.
To create a spark you must push the control knob in (A) and hold in this position for 3-5 seconds to
allow gas flow and then turn anti-clockwise to” HIGH” (B). It can spark to the burner lighting tube
(C). You will hear a “snap” from the igniter and you will also see a 3”-5” orange flame coming from the
burner lighting tube at the left side of the burner (D). Continue to hold the burner control knob in
for two seconds after the “snap”, this will allow gas to flow completely down the burner tube (E) and
insure ignition.
4.
When the burner is alight, adjacent burners will cross light when their controls are turned to “HIGH”.
At “High” setting the burner flame should be approximately 12-20mm long with a minimum of orange
flame. Turn the gas control fully anticlockwise for minimum setting.
5.
Should you have any difficulty lighting your gas grill following the above steps, contact your dealer for
advice.
6.
After completion of preheating, turn all burners to the low position for best cooking results.
TIPS:
Preheat the barbecue for about 10-15 minutes on maximum temperature.
After completion of preheating, turn all burners to the “LO“ position for best cooking results.
If the burners do not ignite after 5 seconds, set all control knobs to off (red bar pointing upwards)
and close the gas valve of the gas cylinder. Wait for 5 minutes. Repeat the above procedure.
MANUAL LIGHTING
If the grill will not light using the normal lighter, use the following procedure for manual lighting.
Use a long match or lighter.
1.
Follow step 1 and 2 (Lighting instruction).
2.
Lift up the grate and place a grillighter or a lit match close to one burner.
3.
Push and turn any knob anti-clockwise to the high position, taking care to protect yourself from the
flames.
4.
When the burner is lit, light the remaining burners. Confirm that each burner is alight before turning
on the next burner.
5.
If a burner fails to ignite, contact your local dealer for assistance.
6.
Follow step 6.
DO NOT LEAN OVER THE BARBECUE WHILE LIGHTING!
WARNING:
If the burner still
does not light, turn
the burner control
knob to OFF and
wait 5 minutes to let
the gas clear before
lighting again.
25