Lighting Instructions
1. Connect the gas cylinder to the barbecue following the instructions
supplied with the regulator.
2. Turn all the control knobs to the ”OFF” position.
3. Before first usage and if the barbecue hasn’t been in use for a while,
check for leaks (see page 11)
4. To light the burner, turn the knob anticlockwise to ”LOW” position,
then push down the knob whilst turn anticlockwise to position and
hold for 4 to 5 seconds, this should light the burner. Check that if the
burner is alight. If the burner has not lit, repeat this process.
5. If the burner has not lit after two attempts, turn ”OFF” the gas tap and
wait 5 minutes before retrying the ignition sequence.
6. When the burner has lit, the burner rate can be adjusted by turning
the knob anticlockwise to any position between the Hi and Low rate
positions.
7. To turn ”OFF” the barbecue, turn the cylinder valve handle or regulator
switch to the ”OFF” position by following the regulator instructions.
Once the burner have extinguished turn the control knob to the ”OFF”
position.
IF BURNER FAILS TO IGNITE, TURN THE CONTROL KNOB AND THE CYLINDER
VALVE OFF (CLOCKWISE). WAIT FIVE MINUTES BEFORE ATTEMPTING TO
RELIGHT WITH IGNITION SEQUENCE. IF THE BBQ STILL WILL NOT LIGHT
USING NORMAL OR MANUAL LIGHTING, REFER TO THE TIPS SECTION IN THE
TROUBLESHOOTING MANUAL, OR CONTACT YOUR DEALER.
!
12