- 14 -
Disarming the System
When you disarm the system, you disarm only the burglar portion of your
system; any smoke or heat detectors and panic keys will remain armed. You
must enter through a designated entry door and disarm the system within
the time allowed. You can have different amounts of time for different entry
points. See your system reference sheet for the times established for your
system.
To disarm your system:
Enter your user code.
If no alarms have taken place, the ARMED light will go off, or the display
shows:
LCD Keypad:
SYSTEM READY
Fixed-Word Keypad:
“Ready” LED lit
LED Keypad:
“Ready” LED lit
If alarms occurred when the system was armed or if a trouble condition
exists, the display shows:
LCD Keypad:
ALM MEM ZN1
Fixed-Word Keypad:
“Arm” LED lit
“Ready” LED blinks
LED Keypad, zone
LEDs:
Fast Blink = alarm or tamper
Slow Blink = bypass
Slow Pulse = trouble, or low
battery
Solid On = zone faulted
Fire alarms will generate a pulsing sound. Burglary alarms will sound a
steady tone at the keypad(s) that lasts until the alarm is cleared or until the
amount of time (alarm timeout) set by your system installer has passed. If
the amount of time set by your installer has passed and the alarm has not
been cleared, the audible alert switches to a pulsing sound that remains
active until the alarm is cleared.
IMPORTANT:
If an intrusion has taken place while you were away, do not
enter until the location has been checked. Call for help from a neighbor's
house and wait there for the police.
To clear the display of alarm or trouble conditions and silence the audible
alert:
Enter your user code again.
