You can connect the faytech display with the included 120V/220V plug or the
12V power adapter. Insert one of these power sources into the input (26) which
is l12 VDCIN (found on the right side of the display).
Another alternative is to connect another 12V source to the pigtails on the All-
In-One cable (11). Make sure to connect the +12 V (B) lead to a
positive 12V source and connect the Ground lead (GND) to a ground on the
same power source:
Connect the +12 V cable to a power supply that de12 V DC and 1.1 A. In
most PCs this will be the yellow cable from the power supply (see fig. below)
Connect the ground cable to a stable ground such as the chassis of the PC.
l
l
If you are not absolutely sure how to do this, please hire a professional to make
this power connection for you. Flickering images on the display are indications
that the power connection has not been made properly.
3.
4.
Connect the USB cable (on one end of the All-In-One cable) to the USB port
on your PC (only for the display with touch function) but only after you are
requested to do so while you are installing the touch software.
The reversing light connection on the All-In-One cable is optional. It's mainly
meant to be used for an automobile application, but it's possible to use it in
other ways. If you connect this lead to the +12V side of the backup lights and
also connect a rear mounted video camera to AV2, the monitor will
If you do not use the two power cables of the All-In-One cable
(red and black) please cap them off or otherwise isolate them
so they will not create a short which could permanently damage
the display.
Display Connection
Tip:
faytech Ltd. 2009
C
34
Remember:
you must connect only
ONE power source to
the touch display.
automatically switch its source to AV2 when you put the car in reverse and will
automatically return to VGA when the car is taken out of reverse.
On the right side of the display is another USB port. If you plug the USB
connector from the All-In-One cable into a USB port on your PC but you do not
load the touch drivers, then this port is an extension of the USB port on your PC.
You can connect a USBstick or any other USB device to your PC by using this
USB extension port.
5.
Display Connection
Display Operation
1.
2.
3.
For a description of the buttons on the display see the previous section titled
“
Components
”
.
The remote control: The remote control functions are similar to the buttons
on the display. Before using the remote for the first time, please remove the thin
plastic on the back side so that the battery makes contact and the remote
control has power.
OSD-Menu-Operation in VGA mode: The Menu operation of the faytech
display is simple and logical. You have three control buttons. MENU, VOL +/ -.
Pressing MENU brings up the OSD menu; with VOL +/- you can navigate
through the main menu. By pressing MENU again you switch to the submenu.
Use VOL+/- to select the appropriate item in the submenu. The selected item will
be marked in red. To change the value of an item please use VOL +/
–
. Press
MENU again to save the changes and you can then navigate again with the Vol+
and VOL- buttons. To return to the main menu, select EXIT and press MENU.
OSD-Menu-Operation in AV mode: The Menu for either AV signal has almost
the same tabs and functions as when in VGA mode. The
“
Picture Settings
”
tab is
not available. The
“
Auto Calibration
”
,
“
Auto Color
”
and
“
Color Temperature
”
functions under
“
Color Settings
”
are replaced with
“
Saturation
”
and
“
Hue
”
.
4.
35