Fayat DYNAPAC DRP40DX, Operating Instructions Manual

Page: 52 / 110

3. Turn the ignition key to position “I”.
ð
The warning buzzer sounds.
4.
The starter switch is designed with a re-start
lock. The ignition key must first be turned
back to position “0” before a new starting
attempt can be made.
NOTICE!
Components may get damaged!
– Starting attempts should not exceed 30
seconds uninterrupted or max. 3 times
for 10 seconds. Then allow the starter to
cool down to ambient temperature.
– If the engine has not started after these
attempts, determine the cause.
Turn the ignition key through position “II” to position “III”.
ð
The starter cranks the engine.
The warning buzzer stops.
NOTICE!
Danger of engine damage!
– Warm up engine for a short while
before starting work. Do not operate
the engine immediately under full
load.
B-ELE-0070
Fig. 30
B-ELE-0072
Fig. 31
Operation – Starting the engine
DRP40DX 52