Fayat Group SCARAB M25H, Operating And Basic Maintenance Instructions

Page: 37 / 74

Manual No. SCAZ043075 1.7.01 37 E&OE
M25H Road Sweeper Operating Instructions
Dust suppression system
Low pressure water system
The low pressure water is used on the front brushes, suction tube(s), side
brush(es) and wide sweep brush. To operate any of these functions the
relevant button(s) on the main panel must be selected when in sweep mode.
The front and side brush(es) are fitted with shut off valves.
Filling the water tank
1. Open the driver’s side hopper locker.
2. Attach water hose with hydrant adaptor if available to the connector
q
or
insert a water hosepipe.
3. Fill with clean water to the top of the level indicated by the side of the
sight tube
w
.
4. When full remove hose and close locker door.
Draining the water system
It is vital that the water system is drained totally if the air temperature
is expected to fall to 0°c or below.
1. Remove the strainer from the inside of the low pressure water filter
e
,
which is located under the rear right of hopper. They can be opened
without raising the hopper. Repeat for the high pressure water filter
r
, if
fitted, it is located under the rear left of the hopper.
2. Open all the brush shut off valves.
3. With engine running, sweep mode on .
4. Switch on all water spray functions, on the main control panel, until the
system is dry. See page 28.
1
2
3
4
Water Filter
Front Brush Shut-Off Valve Side Brush Shut-Off Valve