Fayat Group DYNAPAC S100, Operation & Maintenance Manual

Page: 14 / 101

P a g e 14 | 101
MACHINE OPERATION
Controls
Movement control
The control lever has 4 functions:
1. To put the machine in neutral to stop it or start the engine.
2. To engage the wheel drive: Gradually push the control towards the front to adjust the
speed.
3. To stop the machine, release the control.
4. To reverse, push the control to the back, beyond neutral. This can be done whenever the
engine is running and allows instant forward/reverse operation. When the control lever is
released from the reverse position, the machine automatically switches to neutral.
5. Depending on the application, work is done in forward (chip spreading) or backward
motion (hot mix spreading).
Parking brake
It is automatic.
When the movement control is released, the machine is automatically
immobilized due to the hydrostatic transmission. The same applies when the engine is
stopped.
Accelerator control
By moving the accelerator lever towards the front (towards the
engine), the engine speed is increased until the maximum regulated
speed is reached. By bringing the accelerator backwards (towards the
operator), the engine speed is reduced.
There is a built-in choke located after the maximum speed, with the
lever pushed fully forward.
To stop the engine, place the lever
completely to the rear, beyond the idling point.