Fayat Group BOMAG BW 226 DH-4i BVC, Operating Instructions Manual

Page: 26 / 31

Working on the air conditioning
Faults on the air conditioning should only be remedied by profes-
sional personnel.
According to the regulation for pressure reservoirs all pressure res-
ervoirs must be repeatedly inspected by a specialist.
In connection with this inspection the drier/collector unit must be
visually examined twice every year. During these inspections spe-
cial attention must be paid to corrosion and mechanical damage.
Do not perform welding work in the vicinity of the air conditioning.
Danger of explosion!
Do not clean the condenser in the air conditioning system with a
hot water jet. Danger of explosion!
Do not release refrigerant into the atmosphere, but dispose of envi-
ronmentally.
Cleaning work
Do not perform cleaning work while the motor is running.
Do not use gasoline or other easily inflammable substances for
cleaning.
When cleaning with steam cleaning equipment do not subject elec-
trical parts and insulation material to the direct jet of water, or cover
it beforehand.
n Do not guide the water jet into the exhaust and into the air
filter.
After maintenance work
After all maintenance work is completed reinstall all guards and
safety installations.
Mark a defective machine by attaching a warning tag to the
steering wheel.
Repair work must only be performed by qualified and authorized
persons. Use our repair instructions for this work.
Exhaust gases are highly dangerous! Always ensure an adequate
supply of fresh air when starting in closed rooms!
Do not work on the fuel system while the engine is running -
danger to life!
The system is under high pressure! Keep away from leakages in
the high pressure system, because fuel squirting out may cause
severe injury. After shutting down the engine wait for another
minute, until the pressure has dropped to a permissible level. In
case of leakages you should contact the Service Department of the
engine manufacturer and refrain from starting the engine.
Test
The safety of compaction equipment must be checked by a spe-
cialist as required in dependence on the application and the oper-
ating conditions, however at least once every year.
Repair
Safety regulations
BW 226 DH-4i BVC 26