Operation
BOMAG
28
BT 60 / BT 65
Fig. 23
l
Set the fuel valve (Fig. 23) to "STOP" position
(closed).
Fig. 24
l
Pull the rope by the starter handle (Fig. 24) un-
til resistance can be felt.
l
Let the starter handle run back to initial posi-
tion.
i
Note
This procedure protects against moisture deposits
inside the engine.
4.6
Changing the tamper foot
plate
Fig. 25
l
After changing the tamper foot plate (Fig. 25)
tighten the 4 fastening screws with a tightening
torque of 60 to 70 Nm (44 to 52 ft.lbs).
i
Note
When changing the tamper foot to a different width
use only genuine BOMAG parts.
After changing the tamper foot check the engine
speed, adjust it if necessary.
Go
to
Discount-Equipment.com
to
order
your
parts
