FAVORIT MS 3000, Instruction Manual

Page: 21 / 110

Recommended usage:
If you want to obtain better results while using combined detergents,
add salt and rinse aid into your machine and adjust the water hardness setting and the rinse aid
setting to the lowest position.
Solubility of the tablet detergents produced by different companies can vary
depending on the temperature and time. Therefore, it is not recommended to use
such detergents in short programs. It is more suitable to use powder detergents in such
programs.
Warning:
Should any problem, which you have not encountered before, arise with the use of
this type of detergents, contact the detergent manufacturers directly.
When you give up using combined detergents
•
Fill the salt and rinse aid compartments.
•
Adjust the water hardness setting to the highest position and run an empty-wash.
•
Adjust the water hardness level.
•
Make the suitable rinse aid setting.
Filling with rinse aid and making the setting.
20
To fill the rinse aid compartment, open the rinse-aid compartment cap. Fill the compartment
with rinse aid to the MAX level and then close the cap. Be careful not to overfill the rinse aid
compartment and wipe up any spills.
In order to change the rinse aid level, follow the below steps before turning on the
machine:
• Turn the knob to the “off” position.
• Push the “Start/Pause” button and hold it down.
• Turn the knob counter clockwise one step.
• Hold down the “Start/Pause” button until the LEDs flash twice.
• The machine will display the current setting.
• Set the level by pushing the “Start/Pause” button.
• Turn the knob to the “off” position to save the setting.
The factory setting is “4”.
If the dishes are not drying properly or are spotted, increase the level. If blue stains form on
your dishes, decrease the level.
Level Brightener Dose Indicator
1 Rinse-aid not dispensed Wash LED is on.
2 1 dose is dispensed End LED is on.
3 2 doses are dispensed Start/Pause LED is on.
4 3 doses are dispensed Wash and End LEDs are on.
5 4 doses are dispensed Wash and Start/Pause LEDs are on.