FAURE FSG25249, User Manual

Page: 4 / 36

• Eggs in their shell and whole hard-boiled eggs should not be heated in the
appliance since they may explode, even after microwave heating has
ended.
• The appliance should be cleaned regularly and any food deposits removed.
• Failure to maintain the appliance in a clean condition could lead to deterio-
ration of the surface that could adversely affect the life of the appliance and
possibly result in a hazardous situation.
• The temperature of accessible surfaces may be high when the appliance is
operating.
• The microwave oven shall not be placed in a cabinet unless it has been
tested in a Cabinet.
• The rear surface of appliances shall be placed against a wall.
• Pay attention to the minimum dimensions of the cabinet (if applicable). Re-
fer to the installation chapter.
• The appliance must be operated with the decorative door open (if applica-
ble).
• Do not use harsh abrasive cleaners or sharp metal scrapers to clean the
glass door since they can scratch the surface, which may result in shatter-
ing of the glass.
• If the supply cord is damaged, it must be replaced by the manufacturer, an
authorized Service or similarly qualified persons in order to avoid a hazard.
Safety instructions
Installation
Warning! Only a qualified person must install
this appliance.
• Remove all the packaging.
• Do not install or use a damaged appliance.
• Obey the installation instruction supplied with the
appliance.
• Always be careful when you move the appliance
because it is heavy. Always wear safety gloves.
• Do not pull the appliance by the handle.
• Keep the minimum distance from the other applian-
ces and units.
• Make sure that the appliance is installed below and
adjacent safe structures.
• The sides of the appliance must stay adjacent to
appliances or to units with the same height.
Electrical connection
Warning! Risk of fire and electrical shock.
• All electrical connections should be made by a
qualified electrician.
• The appliance must be earthed.
• Make sure that the electrical information on the rat-
ing plate agrees with the power supply. If not, con-
tact an electrician.
4