EN -37-
Temperature indicator
In order to help you better set your refrigerator, we have equipped it with a temperature
indicator located in the coldest area.
To better store the food in your refrigerator, especially in the coldest area, make sure
the message “OK” appears on the temperature indicator. If « OK » does not appear,
this means temperature has not been set properly
It may be difficult to see the indicator, make sure it is properly lit.Each time the
temperature setting device is changed, wait for the stabilisation of the temperature
inside the appliance before proceeding, if necessary, with a new temperature setting.
Please change the position of the temperature setting device progressively and wait at least
12 hours before starting a new check and potential change.
NOTE:
Following repeated openings (or prolonged opening) of the door or after putting
fresh food into the appliance, it is normal for the indication “OK” not to appear in the
temperature setting indicator. If there is an abnormal build up of ice crystals of ice crystals
(bottom wall of the appliance) on the refrigerator compartment, evaporator (overloaded
appliance, high room temperature, frequent door openings), put the temperature setting device
on a lower position until compressor off periods are obtained again.
Store food in the coldest area of the refrigerator.
Your foods will be better stored if you put them in the most appropriate cooling
area. The coldest area is just above the crisper.
The following symbol indicates the coldest area of your refrigerator.
To be sure to have a low temperature in this area, make sure the shelf is located
at the level of this symbol, as shown in the illustration.
The upper limit of the coldest area is indicated by the lower side of the
sticker (head of the arrow). The coldest area upper shelf must be at the
same level with the arrow head. The coldest area is below this level.
As these shelves are removable, make sure they are always at the
same level with these zone limits described on the stickers, in order
to guarantee temperatures in this area.
OK
Accessories
Ice Tray
•
Fill the ice tray with water and place in the freezer compartment.
•
After the water has completely frozen, you can twist the tray as shown below to remove
the ice cubes.
