Rough in:
1. Carefully remove the mixer from the box and screw the threaded mount sleeve
into the base of the mixer, firmly hand tighten only.
2. Press the large O-ring into the base of the dress ring and slide the dress ring
over the mount sleeve to locate into base of mixer.
3. Thread the 2 flexi hoses into the base of the mixer. The blue braided hose
connects to the port marked “C” and the red hose to the “H” port. Thread the
hoses in hand tight only.
4. Bring the tap into position, press the flexible hose nuts through the tap hole and
Insert the mixer into the hole (if the hole is deep and does not permit both nuts
to go through you can remove one hose and fit it once the tap is mounted)
5. Insert the three Phillips head screws into one side of the brass mount nut (not
to protrude through the other side) and locate the stainless horseshoe washer
over the nut.
6. Slide the black rubber washer over the hoses and mount sleeve under the
bench/sink then screw the mount nut onto the mount sleeve with the stainless
washer to the top.
7. Position the tap then hand tighten the brass mount nut.
8. Fasten the tap in place with the 3 Philips screws. Not a lot of force is required to
secure the mixer firmly. Do not overtighten.
9. Flush the water supply lines by running water through the mini supply stop taps
into a bucket.
10. Connect the hoses to the water supply mini stop taps, Blue braid to the cold
supply and red braid to the hot supply. Nip up very gently with a spanner. Do not
overtighten.
11. Open the handle of the mixer then slowly open the supply stop taps. Once the
air has exited the tap you can close the tap handle.
12. Run and operate the tap, check for any leaks or issues. If you have any concerns
contact Faucet Strommen before leaving the site.
Sink Hole ø
34-35mm
Bench
Thickness
Max 45mm
