FBs-W2C User Manual
4
1.5
Installation
Directly plugged FBs-W2C in port 0 (port 1 for HB1 series). It can automatically
detect the baud rate. After the detection, it will set the port 0 (port 1 for HB1
series) baud rate as 115200 bps.
If using HB1 series PLC, please update the firmware version of W2C to V1.3.1 or
above. The baud rate of the port 1 cannot use 4800 bps. For instructions on
firmware upgrade, please refer to Chapter5 Firmware Upgrade (OTA).
1.6
LINK LED Status
LINK LED is in red, the LED will have different signal status depends on FBs-W2C
currently state. Table 3 shows the various signal status of LED.
Table 3: LINK LED Operation Mode
Connection Status
LINK LED
Connecting
On and off every 3 secs
Disconnected
Off
Execute Smart Config
Continuous flash
Execute OTA
Triple flash
