Bottom Bracket
Top Bracket Seat/Saddle Secured
Unfastened QR Seat post Clamp
Fastened QR Seat post Clamp
11) Next thing were going to install is going to be your display and your controller, which was
in a little brown box located inside of your components box. For this, you’re going to need your
small 3 mm allen key. Your display is the larger piece with a screen, and your controller is your
smaller circular piece with three buttons on it. Start by unfastening the two screws located on the
back of the display and placing it centered over the top of your stem head (middle of your
handlebars).
NOTE: Do not over tighten these allen nuts due to the possibility of snapping
the plastic mounting plate.
Face the screen upwards, place the back brackets in the correct
spot, and fasten the display onto your handlebars. When that's finished, unfasten the allen nut
bolts on the back of your controller and mount it next to the left grips on the handlebars near the
throttle. Worry about setting up your display at the end of the assembly, and you will see the
attached instructions at the end of this manual.
Display Controller
