Shark Byte
7
CH
FCC (MHz)
CE (MHz)
1
5660
5735
2
5695
5770
3
5735
5805
4
5770
5839
5
5805
NA
6
5839
NA
7
5878
NA
8
5914
NA
TX5S.1
SPECIFICATIONS
Weight:
10.3g including camera and cable (without antenna), 5.2g for VTX only
Dimensions:
Camera: 14 x 14mm with 19 x 19 adaptor
VTX: 32.5 x 32.5 x 5 mm
Coaxial cable: 85mm
Mounting Pattern:
VTX: 20 x 20mm, M2
Operating Frequencies:
Transmitting Power/ Power Consumption:
25mW: 5.1W
200mW: 6.7W
IO Interface:
u.FL
UART: 3.3V
Update Port: 7-pin SH 1.0
Supported Flight Control System:
BetaFlight: 4.1 or above (MultiWii API version 1.41)
iNav 2.3 or above
Input Power:
7-26V
Operating temperature:
32
°
-104
°
F (0
°
-40
°
C)
Adjusting VTX and Camera Parameters with the Keypad
The VTX or Camera parameters can also be set with the attached keypad.
Camera:
The 5-way joystick button (1) is used exclusively for camera settings. Settings and options are displayed
on-screen on the live video for this configuration mode.
•
Press Middle: Enter
•
Press Up: Up
•
Press Down: Down
•
Press Left: Left
•
Press Right: Right
VTX:
The select button (2) and 7 segment LED display (3) are used exclusively for setting VTX parameters.
To change channel:
•
Short press the select button (2), the 7 segment LED display (3) will show the current channel number (1-8),
another short press will cause it will change to next channel. If no changes are made after 15 seconds, the 7
segment LED display (3) will turn off and the setting will be saved.
To change power level:
•
Press and hold the select button (2) for 3 seconds, the 7 segment LED display (3) will blink ‘P’ then show current power level (1.=25mW, 2.=200mW,3.=500mW).
To make a change, short press the select button (2) to cycle to the next power level. If no changes are made after 15 seconds, the 7 segment LED display (3) will turn
off and the setting will be saved.
To select Low Power (LP) mode:
•
Press and hold the select button (2) for 10 seconds, the 7 segment LED display (3) will blink ‘P’ then ‘L’, show “O” (ON) or ‘F’ (OFF). If no changes are made after 15
seconds, the 7 segment LED display (3) will turn off and the setting will be saved.
3
1
2
1
5-way joystick button for Camera
2
Select Button for VTX
3
7 Segment LED Display for VTX
TX5M.1 Keypad Connection
TX5S.1 Keypad Connection
