2015 Adaptive Technologies Group, Signal Hill, CA 90755(562) 424-1100
R2-08270-115
Figure 2
Figure 3
Step 5:
Install a M10 eyebolt on the rear plate and into the rear rigging
point of the center speaker for shallow tilt angles.
For steeper angles, Install the M10 x 35mm long eyebolt on
the bottom rear of the center speaker. This Will be used for
the pull back (Figure 3).
Step 6:
Secure the front joiner plates to the top front of the speakers.
Use the M10x50mm long eyebolts to the secure the side
speakers to the front joiner plate (Figure 1).
Step 7:
When all plates are in position, tighten all screws permanently.
Step 8:
Use the two front M10 eyebolts from the front joiner plates as the
main speaker suspension points. Use the back eyebolt as a
pullback point to adjust the tilt angle of the speaker cluster
(Figure 3).
For steep angles, use eyebolt installed on the bottom rear of
the center speaker as the pull back point to achieve the
desired tilt angle (Figure 3)..
Step 9:
Check all hardware connections before hoisting cluster.
