2015 Adaptive Technologies Group, Signal Hill, CA 90755(562) 424-1100
R2-08270-115
Figure 1
FASPAC
TM
FP-AM7215-3X1
3 WIDE X1 DEEP PLANAR ARRAY CONFIGURATION
The FP-AM7215-3X1 planar array kit give designers, contractors and audio
consultants the ability to create a three wide AM7215, or AM5215 speakers in a tight
pack planar array configurations. The FasPac
TM
provides a method of flying a tight
pack array while offering the capability of allowing cabinets to be adjusted relative to
each other to find the optimum sound directivity. A series of holes are provided to
easily adjust the splay angle from 0° to 30° at an increment of 2.5 degree.
Installing speakers must be performed by experienced professionals
. If in
doubt about the integrity of the structure you are mounting or suspending to or not
sure about the proper hardware or method to use, consult a certified rigging
company.
Package contents:
4 pcs
7-2645 Front Joiner Plate
2 pcs
7-2647 Rear Joiner Plate
14 pcs
Button head socket screw, M10x1.5-45MM long
15 pcs
M10 flat washers
2 pcs
M10 x 50mm long eyebolt
2 pcs
M10 x 35 mm long eyebolt
CAUTION:
PLEASE READ CAREFULLY BEFORE PROCEEDING
Due to the wide variety of building structures, materials and suspension methods,
these instructions assume that the installing contractor/installer will exercise good
judgment in selecting the proper mounting area and hardware. As a guide, the
installation, when complete, should be capable of supporting at least 5
times the actual load.
Follow building code requirements to safely suspend the speakers to the
building structure
Step 1:
Flip speakers so that the bottom is facing up. Unscrew existing speaker
screws and discard.
Step 2:
Determine the splay angle of the speaker and the holes to use on the front
joiner plate (Figure 2).
Step 3
:
Install the rear joiner plate on the rear rigging inserts to secure the side
speakers to the center using the slots of the plates. Use the provided M10
screws and washers (Figure 1). Install two front joiner plates on the two
front rigging inserts of the speakers using the corresponding holes for the
appropriate splay angles using the, screws, and washers (Figure 1). Make
sure the markings on the plates are facing up. Do not tighten screws;
leave it snug until all plates are in position.
Step 4:
Slowly flip the speaker assembly so that the tops of the speakers are
facing up. Unscrew the speaker screw and discard (Figure 1).
