311
“EGA Spółka z o.o.” Spółka Komandytowa ul. Rzeczna 1, Nowa Wieś Rzeczna
83-200 Starogard Gdański tel/fax +48 58 56 300 80,
12
manufacturer. Most materials will be easy to spray if they are properly diluted.
3.
Strain the material through the filter, material or paint strainer.
4.
Fill the container in ¾ and turn on the compressor.
WARNING!
Never exceed the maximum pressure of the gun or any other part of
the compressor’s system.
5.
After connecting the gun with the air supply, you should check if the paint
container, container and the air duct are tightly fixed to the gun.
6.
Use a piece of a cardboard or another material in purpose to set spraying pattern.
WARNING!
Never aim the tool or cover with paint yourself or anybody else as it
may cause injuries.
7.
Test the consistency making a few shots on the cardboard. If the material is still too
thick, add a small amount of the solvent. DISSOLVE CAREFULLY! Do not
exceed amount of solvent recommended by the paint manufacturer.
Adjustment
Adjustment of the spraying pattern
：
Turn the knob to the right until the spraying
will not be round, turn to the left to make an ellipse spraying shape.
Adjustment of liquids (paint): Turn the knob into direction of the clock movements
to reduce amount of paint, opposite direction will increase it.
Directions for use
1.
Start spraying. Always hold the gun at the right angle during work.
2.
Hold the nozzle about 15-30 cm from the work surface. Hold the gun
perpendicularly to the area of spraying, next drag it in parallel several times,
stoppage the motion of the gun in the middle of spraying will cause paint build-up
and its escape. The gun should not be rotated from side to side (picture) while
painting. It will cause paint collecting in the center excluding sides.
Summary of Contents for 311
Page 17: ......