QUICK START GUIDE
For more information including FrameFAST instructional videos visit fastenmaster.com.
For warranty assistance contact FastenMaster at 800·518·3569 or email your request
to [email protected]. FastenMaster 153 Bowles Road Agawam, MA 01001
Models:
Contents:
(1) FrameFAST tool
(corded or cordless)
(1) truss to plate
installation head
(2) replacement bits
(1) Quick Start Guide
The FrameFAST tool includes the following items inside the plastic case:
(1) bit replacement tool
(1) Milwaukee/DeWalt
literature packet
(1) FrameFAST
limited warranty
FMTOOL-T2TP
FrameFAST Tool (corded with Milwaukee Drill)
FMTOOL-T2TP-MILC
FrameFAST Tool (cordless with Milwaukee Drill)
FMTOOL-T2TP-DWC
FrameFAST Tool (cordless with Dewault Drill)
PART NO. FMFFQUICKSTART (0620)
➊
Release Red Thumb Lock
The FrameFAST Tool is packaged with a red
bit changing tool. To remove and replace a
driver bit position the tool upright, with the
motor gently placed on the floor. Carefully press
downward on the telescoping FrameFAST tool.
To avoid injury, never lean directly over the tool
when compressing and be sure to grasp the tool
BELOW the red thumb lock.
Once fully compressed, the driver bit will
be visible.
➋
Driver Bit Removal
Slide the red bit changing tool over the driver bit.
Continue to ensure that the FrameFAST tool remains
fully compressed and gently press down on the bit
changing tool to disengage the driver bit.
➌
Insert New Driver Bit
Next, insert the new driver bit through the driver bit
replacement tool, and into the FrameFAST tool. Be sure
that the bit is properly locked in place by pressing down
on the red bit replacement tool . The bit should fall right
into place within the locking chuck. Remove the red bit
replacement tool and store in the durable plastic case.
Check that the driver bit is secure. It should not pull out
of place without the use of the driver bit replacement
tool. Once the bit is securely replaced, reinstall the
FrameFAST installation head as shown in steps 3
and 4 of the FrameFAST quick start guide.
Replacing Driver Bits
Lift
Thumb
Lock
Push
Down
Lift
Thumb
Lock
Push
Down