Fastech Ezi-SPEED ESD-120-C, Manual

Page: 45 / 93

-45-
Display Detail
Indication Display the monitor, parameter, alarm, warning. etc.
Operating Switch
The motor is started by setting it to the “RUN” position.
Setting it to the “STAND-BY” position stop the motor
Rotation Direction Switch
Change the rotation direction of the motor with rotation direction
switch.
Setting Button
Changes the speed and parameters. The value is set when the “S”
button is pressed after changes are made.
Protective Earth Terminal Ground either one of the protective earth terminals
Sensor Connector CN3 Connects to the signal connector of the motor.
Motor Connector CN2 Connects to the power connector of the motor.
I/O Signal Connector CN4 Connects with the I/O signals.
Main Power Connector CN1 Connects to the main power supply and regenerative resistor
7.2 Rotation direction switch
When setting to FWD and REV, Motor rotation direction is different for status of rotation direction
switch. Rotation direction of below picture is from the shaft side.
Rotation Direction Switch
External Operation Input
FWD input REV input
“FWD”
Rotation direction of motor :
clockwise Rotation direction of motor :
counterclockwise
“REV”
Rotation direction of motor :
counterclockwise Rotation direction of motor :
clockwise
CCW(REV) CW(FWD)