Troubleshooting Chart
Symptom Corrective Action
Operation
Shake excess water from hands.
Place hands under the outlet to start operation.
Rub hands lightly and rapidly.
Stops automatically when hands are removed.
Maintenance
Easy to maintain. If the surface is dirty or dusty
just wipe to clean.
Blower motor stops running
Turn off power to the dryer at electrical panel.
Remove cover.
Check all wiring connections from terminal board to the
motor.
Check blower wheel and spin to make sure it rotates freely:
Look for objects blocking the free movement.
Replace cover and turn on power to the hand dryer.
If motor fails to start, have a qualified electrician check the
Push-On-Switch, thermostat, motor and capacitor for proper
operation. Replace if necessary.
Dryer blows cold air
Turn off power to the dryer at the electrical panel.
Remove cover.
Check all wiring connections to make sure all terminals are
firmly mounted in place and the wire insulation is in
good condition.
Have a qualified electrician check the thermal cut off and
heating element.
Replace cover, turn on power to the hand dryer. If dryer
continues to blow cold air, replace defective thermal cut
off and/or heating element.
Dryer does not respond
to hand movement
Make sure power is on and available to the unit. Place
hands under sensor.
A clicking sound indicates sensor is functioning properly.
No clicking sound would indicate a bad sensor and/or
contactor.
Replace if necessary.
Dryer will not shut off or will
not run for a complete cycle
Replace timer assembly
Operating Instructions and Parts Manual
Hand Dryers
3
2
1
3
4
5
6
7
8
9
12
11
13
10
14
15
Operating Instructions and Parts Manual
Hand Dryers
4
Automatic
distributed by
RESTROOM DIRECT 704 . 937. 2673
www.
RestroomDirect
.com
