6
Install Receiver Mounting Brackets
^
WARNING
Receiver mounting bracket weighs
approximately 105 lbs. Use an appropriate
lifting device to prevent injury.
1. Install left-side mounting bracket (1) to tractor with M20 x
60mm GR 10.9 bolts (2) and M20 flat washers. Refer to
torque charts in this instruction for bolt torque values.
2. Install right-side mounting bracket (3) to tractor with M20
x 60mm GR 10.9 bolts (2) and M20 flat washers. Refer to
torque charts in this instruction for bolt torque values.
3. Place rubber isolators (4) on top and bottom of bracket.
4. Place plate (5) on top of isolator and insert four ¾ x 9
''
GR5 bolts (6) through plate and both isolators.
5. Repeat steps 3 and 4 for left-hand side receiver mounting
bracket.
^
WARNING
Receiver mounting tube weighs approximately
105 lbs. Use an appropriate lifting device to
prevent injury.
6. Raise receiver mounting tube (7) into position with radar
bracket facing forward and install eight ¾
''
centerlock
nuts. Tighten all eight bolts
equally
so some bulge is seen
on the rubber isolators.
Install Setscrews
1. Install four setscrews (1) in receiver tube. Verify setscrews
do not extend inside tubes.
Summary of Contents for 8295RT
Page 14: ...14 Plumbing...
