FMT4000
Instruction Manual
Fast Mover Tools
T: 01582 661993 F: 01582 667100 E: [email protected]
W: www.fastmovertoolsuk.com
Assembly Instructions
1
Do not tighten nuts and bolts until full assembly is complete.
2
Attach two side frame to cross tube using 5/16” x 11/4” bolts.
3
Attach cutting bar to side frames using 1/4” x 11/2” bolts, washer and nuts.
4
Attach handle to top of side frames using 5/16” x 11/4” bolts.
5
Insert 1/4” x 31/2” bolts through side frames and secure with 1/4” nut.
6
Secure all bolts and nuts.
7
Screw 1 wing nut on eack of the 1/4” x 31/2 bolts.
8
Slide 1/4” washer on and put on tape reel and hub
Introduction
The FMT4000 is designed to take an 18”/450mm Roll of Masking Paper. Can be used as wall mounted or floor
standing
General Safety Instructions
1
Use this tool on a smooth, level, non-slip surface and always keep your working environment clean
and tidy.
2
Do not use this tool whilst under the influence of drugs, alcohol and intoxicating medication.
3
Do not use this tool for any other purpose other than that for which it is intended. This tool is not
intended as a tethering point.
4
Do not allow children and other unauthorised persons to use this equipment.
5
This tool has sharp edges. It is strongly recommended that hand protection is worn when using this
tool.
6
Always be aware of those around you and keep in mind that your actions have a direct effect on your
colleagues and visitors.
7
Always use suitable fixings if using this tool as a wall mounted unit.
Parts Diagram
Wall Mount Detail
FMT4000_Product Instructions 22/02/2013 15:18 Page 2
