If the customer happens to buy two sets, please refer to the below graphics to connect and disconnect the ramps.
Picture 1: connect two ramps.
Picture 2: Disconnect the ramps.
Similar and refer to the IM of
AD16469,
ISSUE
CAUSE
CORRECTION
Vehicle does not work, red LED on transmitter is
flashing SLOWLY.
Battery in transmitter is low.
Replace batteries with new 4x 1.5V AA batteries. (Alkaline batteries are
recommended)
Vehicle does not work, red LED on transmitter is ON, red
LED on vehicle flashes SLOWLY
Rechargeable battery is LOW.
Re-charge the vehicle by following charging instruction on page 1. Make sure USB
charging cable is well connected to
charging port on the vehicle.
Note: RED light in USB will turn ON while charging. RED light will turn OFF to indicate
charge is complete.
Vehicle runs by itself after vehicle and transmitter are
turned ON.
Trigger of transmitter is not in the
correct position.
Turn vehicle and transmitter OFF. Next, turn steering wheel of transmitter clockwise
and turn transmitter ON at same time.
Then turn vehicle on.
Note: Do not touch trigger of transmitter during this step.
Trouble Shooting
Summary of Contents for XPS 1-24 Nitro Racer AD17268
Page 7: ......
