2003
–
2004 CP3 (Injection Pump)
D.
Disconnect factory fuel line from inlet side of the factory injection
pump, Install the DIPF-1003 fuel fitting into this inlet port. (Note:
This is where the suction fuel line from the fuel filter enters the injec-
tion pump.)
E.
Measure and cut fuel line. Insert PL-2003 90° Push-Lok fitting using oil. Install fitting onto DIPF-
1003. Torque to 18 ft/lbs.
Note: Secure all fuel lines with cable ties. Cable ties are an economical way to prevent the
possibility of problems occurring!
A.
Route suction line to ‘T’ port . Cut FL-1002 to length. Insert PL-
1005 in line using oil. Attach to 10-301. Torque to 18 ft./lbs.
B.
Route fuel line from the ‘R’ fitting to RM-1004 in the filler neck
with a gentle bend. Cut and insert the PL-1005 fitting to the hose.
Use oil. Attach fitting to the ‘R’ port. Torque to 18 ft/lbs.
C.
Insert PL-1005 in remaining fuel line. Connect to the ‘E’’ port of
the FASS system. Use oil. Torque to 18 ft./lbs. Route this line up to
the injection pump.
NOTE: Hose clamps are not recommended for push lock fittings
and can damage the strength of hose. They will hold up to
300psi! Use oil on fittings and inside fuel line when installing
Push-Lok fittings
Befo
re starting installation please review contents page to insure all necessary parts are included. Please
call Diesel Performance Products for any missing or incorrect items. 636-433-5410
Step 4:
Install Fuel Line
Caution: Do not use sealant on AN fittings.
