This equipment falls within the scope of the Directive 2011/65 /EU. The crossed-out bin symbol on
the product and / or its packaging means that at the end of its life the product must be treated
separately from household waste and must therefore be sent to the appropriate disposal and
recycling centers. This operation is the responsibility of the user. The disposal of the product in the
dedicated dedicated facilities helps to avoid possible negative effects on the environment and
favors the recycling of the materials that compose it.
INSTALLATION OF THE CABLE REEL
INSTRUCTIONS FOR USE
DISPOSAL INFORMATIONS
AUT
O
MAT
IC C
ABLE REE
L
This cable reel can be installed on the wall or ceiling. Take appropriate small parts for a good fixing. Install
the cable reel at a maximum of 3 meters from the floor.
Connect the input plug (G) to the mains socket. Connect the output socket (F) to the device to be powered
to work (lamp, etc.).
ATTENTION
Before unwinding or rewinding the cable, ALWAYS remove the plugs from the
sockets.
•
UNWIND THE CABLE
Pull the cable out manually by pulling it to the desired length. The spring ratchet will activate at specific
points of extraction of the cable. The cable will be blocked by the stop system.
•
REWIND THE CABLE
This cable reel is equipped with a spring rewinding system with an automatic locking system.
Pull the cable manually so that the automatic release of the ratchet is activated. During the rewinding phase,
always guide the cable with your hands. The cable is equipped with a cable retainer bush (D) which stops
its run, preventing the total re-entry of the cable.
ATTENTION
NEVER exceed the maximum permitted load (refer to the technical specifications table
given in paragraph 2 of this manual).
•
THERMAL PROTECTION
This cable reel is equipped with thermal protection. In case of overload, the thermal protection button (B)
snaps outwards, interrupting the passage of electric current. Disconnect the plug from the mains, restore
the correct operating conditions and press the red protection button (B) to restore the passage of electric
current.