Farr Gold Series, Installation, Operation And Maintenance Manual

Page: 10 / 76

SECTION 300-INSTALLATION OF YOUR EQUIPMENT
Table 300.1: Gold Series Assembly Tools
The following items may be required to install your equipment depending on configuration and installation
requirements:
Only trained, authorized personnel should be permitted to service or maintain electrical or safety
components. It is the buyers/installers responsibility to ensure that all applicable electrical and
safety codes are met.
DESCRIPTION INTENDED USE
1 SAE Socket Set General tightening of fasteners
2 Common Screwdriver Electrical connections
3 Phillips Screwdriver Electrical connections
4 Electric Drill or Impact Wrench Installation of self-tapping screws and fasteners
5 Hammer Drill Anchoring to floor
6 Masonry Bit Anchoring to floor
7 Hammer Installing anchors
8
Pliers General use
9 Wire Cutters Electrical connections
10
Wire Nuts Electrical connections
11 Electrical Tape Electrical connections
12
Extension Cord General use
13 Conduit Electrical connections
14 ¾” or larger black iron pipe or equivalent Compressed air connections
15 Fittings for items 13 & 14 Compressed air and electrical connections
16 Thread Sealant Compressed air connections
17 Alignment Punch Aligning holes
18 Forklift or Overhead Hoist Moving and positioning components
19 Electrical Cable (3 PH 230/460 VAC 10 HP) Fan electrical connections
20 Electrical Cable (1 PH 120/240 VAC) Control and lighting electrical connections
21 Wedge anchors or equivalent suitable for the application Anchoring to floor
22 230/460VAC, 3 Ph, 60Hz Electric Motor Starter * Ventilation Fan * (If not supplied with unit)
23 Transit or Carpenters Level Leveling Unit
10