IR REMOTE AND OSD OPERATION
This section describes the operation of the NRS-
DCS processor and remote. See the DVD section
starting on page 11 for details on the operation of
the DVD transport and remote. The IR remote
teaching starts on page 42.
When the unit is first plugged in it will go through
an initializing procedure and display the output
resolution. Do not send any commands to the unit
during this initialization period. Once this initializa-
tion is completed the unit is instant-on.
The remote control allows for easy operation by
simple navigation through the On Screen Display
(OSD) menus. Repeated Pressing of a button tog-
gles through the available choices.
Power On/Off:
Press Power
Select Presets:
Press Preset
Select Input:
Press Input Mode
Activate OSD:
Press Menu
Select OSD Functions:
Press Function Up/Down
Change Value:
Press Value Up/Down
On Screen Display
Control of many functions can be done using
the remote to interact with the OSD.
Accessing the OSD
• Press Menu button to bring up main Index.
• Use Function keys until the triangle at
the top of the OSD turns yellow.
• Use the Value keys to move the tringle
to select a different index and the available
control menu drops down.
• Press Function again to select an adjustment.
• Use Value to adjust. The main menu drops away
and a single line menu appears.
• Use the Function keys return to
the drop down menu.
• Press Menu again to cancel OSD
The OSD consists of four index tabs:
I
nput – Picture – Display – Patterns
Input OSD
FORMATS
Input Select:
DVD-Video-S-Video-YCrCb-RGB-Pass-thru
Aspect
4:3-Letterbox-Anamorphic
Presets-
Recall: Factory-1-2-3-4
Store: 1-2-3-4
TO STORE A PRESET:
• Make all required adjustments.
• Use the Function keys to select Store 1 2 3 4.
• Use the Value keys to select the desired preset
• Press Enter
*Aspect Ratio Selection
Press the Aspect Ratio button to toggle between
the different choices on the OSD. The aspect ratio
selected needs to match the aspect ratio of the
source.
Note:
When using a Wide Angle screen a 4:3
source will have black bars on the left and right of
the image. If filling the entire screen is desired,
select Letterbox. The image will fill the screen but
the top and bottom 1/3 of the image will be cut off.
For 4:3 images on wideangle screens the side bars
of the image can be changed to gray using the
Blanking level control located in the System Setup
menu.
Note:
Anamorphic on a 4:3 screen is not available
on units with scan rates below 720p.
9
Summary of Contents for Native Rate Series
