DVP-1080 FAQ’s
REV 06.20.05
Pearcision
10
C.4. My connection to the display device is Analog, which SET: ACTIVE OUTPUT format
should I choose, RGB or YPrPb?
SET: ACTIVE OUTPUT / ANALOG RGB + DVI and SET: ACTIVE OUTPUT / ANALOG RGB
When DVI is not available, the preferred analog output selection from the DVP-1080 is always RGB,
intimating RGBh/v. This produces the highest quality analog signal, as the processor will have pre-decoded
the incoming video signal to its fundamental constituents of Red, Green, Blue, horizontal sync/vertical sync.
SET: ACTIVE OUTPUT / ANALOG YPrPb
When DVI is not available, and display does not have either an RGBh/v or 15-pin (VGA) input connection,
select
SET:
ACTIVE OUTPUT / ANALOG YPrPb
from within the
SETUP MENU
.
You must also select either
SET: NTSC SCANRATE / 1280x720
or
1920x540
(1080i equivalent), as these
scanrates are the only valid Component video output formats which the display will understand; both the
1280x720 and 1920x540 scanrates are recognized by the display device as a DTV video signal.
Main Menu
