Faro
STEAM
Pag. 9 of 10
3.5.3
Cleaning with steam lance
The lance is used for cleaning surfaces difficult-
to access.
To remove dirt proceed as follows:
press the steam button (Power 2-3
§3.2;
dissolve the dirt with the steam jet;
remove dirt with an absorbent cloth.
NOTE: To eliminate difficult dirt, it is
recommended to use the circular brush
mounted on the lance.
3.5.4
Cleaning floors
Apply an absorbent cloth on the multifunctional brush.
Press the steam button (Power 1-2, see §3.2
Clean the floor without making excessive pressure.
To clean very dirty floors and remove stains, use the brush without of the cloth .
It is not necessary to rub excessively: the steam is sufficient to dissolve the dirt.
Apply a cloth on the brush and remove the dirt.
NOTE: Move the cloth regularly on the brush in order to always use a clean part of the cloth itself.
3.6
Lack of water
The lack of water in the boiler will be indicated by a red light (§3.2)
In this case the heating stops automatically.
What to do
Turn off the boiler heating switch.
Continue to work until all the water remaining in the boiler has been used. If necessary, the self-locking
valve cover cannot be opened. If some water remains into the tank it will not be possible to open the cover
with self locking valve.
Turn off the main switch.
Disconnect the plug.
Unscrew carefully the boiler cover, to allow the residual steam to get out from the boiler
Fill the boiler with water as described in § 3.3 Setup
Reconnect the appliance and start-up as described in point §3.3 Setup
4
MAINTENANCE
Always remove the plug from the socket before carrying out cleaning and maintenance on the appliance.
The following operations must only be carried out by competent and trained people!
In any case, it is recommended to contact our authorized assistance service.
4.1
Removal of lime scale deposits in the steam generator
According to the degree of hardness of the tap water, the machine must be cleaned of lime scale
deposits every 3-4 weeks.
Proceed as follows with the appliance cold and not under pressure!
Remove the plug from the socket