INSTRUCCIONES DE SEGURIDAD / INSTRUCTION DE SÉCURITÉ / SAFETY INSTRUCTIONS / INSTRUÇÕES DE SEGURANÇA / SICHERHEITSHINWEISE /
VEILIGHEIDSINSTURCTIES / INSTRUZIONI DI SICUREZZA /
ΟΔΗΓΊΕΣ
ΑΣΦΑΛΕΊΑΣ
/
ИНСТРУКЦИИ
ПО
ТЕХНИКЕ
БЕЗОПАСНОСТИ
galápago ref. 33301, 33302
faro 14
INSTALLING THE FAN
HANG DOWN STYLE
Slide the canopy and yoke cover on the downrod. Thread the power leads from the fan through the canopy yoke cover,
and downrod. Take extra care not to pull on power wires damage and loose connections could result from any abnormal
pressure on these wire. Set downrod into yoke. Rotate until the holes match. Be careful not to damage the wiring insert
connector pin through the holes. Secure the pin by insert the stop pin through the connector pin.
Tighten the two downrod setscrew. To ensure the setscrew
fully seat against the downrod, it is necessary to back off
locknut until it contacts the setscrew head prior to tightening
the setscrew. When setscrew is tightened against downrod,
locknut should then be tightened against connector yoke,
repeat for both.
Tighten motor screw. Check the strength of this connection by
holding the motor housing in position and turning the downrod
counter clockwise if this connection slips, retighten motor setscrew
and locknut.
Install ball into the hanger bracket opening. The tab opposite of the
hanger bracket opening should fit in slot on ball.
This method is
prefered if the
ceiling is sloped
or valuated, or if
ceiling is extra
high
This method is
prefered if maximum
headroom is required.
The ceiling must be
horizontal.
