Figure 2.
Recommended Cutout Dimensions
The jackscrews included with the TRC-8543 work with panel thicknesses up to
2.21 mm (0.087 in.).
Caution
Tighten the jackscrews to a maximum torque of 0.56 N · m
(5.0 lb · in.).
If your panel is thicker than 2.21 mm (0.087 in.), you can mill out a recessed pocket
for the TRC-8543. The following figure shows the recommended pocket dimensions
and cutout position.
Figure 3.
Recommended Pocket Dimensions
Wiring to the TRC-8543
The TRC-8543 is used with an NI-XNET interface host port.
Figure 4.
TRC-8543 Connections
The TRC-8543 has one 9-pin male D-Sub connector that provides connections to a
CAN bus. The TRC-8543 has pins for CAN_H and CAN_L, to which you connect the
CAN bus signals. Connect these signals using twisted-pair cable.
The port has two common pins (COM) that are internally connected to the TRC-8543
isolated reference and serve as the reference ground for CAN_H and CAN_L. You can
© National Instruments
7
TRC-8543
Summary of Contents for TRC-8543
Page 1: ...TRC 8543 2022 06 30 ...
