English
English
3
4
7 .TV/AV SELECTING BUTTON
8. PICTURE MIRROR BUTTON
9. CHANNEL -/-- BUTTON (one or two digits)
10. MENU BUTTON
11. VOLUME and NAVIGATION SELECTING BUTTONS
12. POWER ON/OFF BUTTON
Battery Installation:
1. Open the Battery drawer by pulling it out.
2. Insert a CR2025 Lithium battery in the Battery drawer.
3. Close the Battery drawer.
Operation:
Aim the Remote Control to the Remote Sensor (9) on the unit.
Maximum operation Range: 5 m.
POWER SUPPLY
Mains operation with PowerAdapter
For use with 230V AC house current, plug the AC/DC cable of the Power Adaptor
(supplied) to the 12V IN jack (15) and the Power Adaptor to a 230V AC wall outlet.
Press the Main Power switch (1) to ON.
Operation with external Battery Pack
1. Open the Battery Pack (supplied) by unscrewing the small black screw and sliding the
battery pack door on the side.
2.
Insert
10 pcs UM-3 (AA) rechargeable batteries (Ni-MH recommended).
Make sure the polarity of the batteries are correct. Close the Battery Pack.
3. Slide the Battery Pack from the top to fix it to the rear of the unit.
4. Plug the AC/DC cable of the Power Adapter (supplied) to the 12V IN jack (15) and the
Power Adaptor to a 230V AC wall outlet.
5. The rechargeable batteries will be charged by the built-in charging circuit when the AC
adapter is connected to 230V.
Do not charge longer than 12 hours (normal charge = 6 hours).
ATTENTION: WHEN USING NORMAL (DRY) BATTERIES (NOT-RECHARGEABLE), DO NOT
CONNECT THE CAR BATTERY ADAPTER OR THE AC/DC POWER ADAPTER.
NOT FOLLOWING THIS INSTRUCTION CAN CAUSE THE BATTERIES TO EXPLODE!
DETACH THE BATTERY PACK WHEN USING THE UNIT WITH THE CAR BATTERY CABLE
OR THE POWER ADAPTER 230/12V.
Car battery operation
The car cigarette lighter adaptor cable (supplied) is useable with this unit for direct use in
any 12V negative ground vehicle. Simply insert the small plug of the cable into the
matching DC jack (15) on the side of the unit and the other end into the cigarette lighter of
the vehicle. The unit can operate between 11 and 15 V DC.
INSTALLING & OPERATING INSTRUCTION
1. Plug the power cord of the AC/DC adapter (included) one end to the DC 12V IN (15)
on the unit and the other end to the 230V outlet.
2. Press the POWER button on the unit (1) unit or on the remote control (12).
3
Pull out the ROD ANTENNA (11) easily and adjust the angle / heading to the best
position to receive TV signals.
4. To turn Off the unit, press the POWER SWITCH (1).
VOLUME ADJUSTMENT
The Volume can be adjusted directly by pressing the VOL- and VOL+ Buttons (2) on the
unit or VOL +/- Buttons on the remote control (11).
MENU OPERATION
1) Picture adjusting function
Press the [MENU] button (2) on the remote control then you will find the picture contents
as follows.
Press [CH+] or [CH-] button to set each item.
Press [V+] or [V-] button to adjust.
PICTURE
BRIGHT
35
COLOR
33
CONTRAST
30
SHARPNESS
22
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
IIIIIIIIIIIIIIIIIIIIIIIIIIIII