19
GROWSPAN
™
GOTHIC PRO GREENHOUSES AND SYSTEMS
Revision date: 06.20.18
INSTALL FRAMING FOR ACCESSORIES (OPTIONAL)
Complete these steps to install the accessory framing:
1. Read the note regarding the installation of optional
accessories at the beginning of the end wall installation
section.
2. Based on the installation requirements and precautions
of the accessory, choose a location in the end wall
where you can mount the accessory, and cut two (2)
1.5" x 1.5" frame tubes to the required length. Consult
the End Wall Diagram.
3. Attach these horizontal frame tubes between the
vertical frame tubes of the end wall (at the required
height determined by the installation instructions
included with that accessory) using QH1330 brackets.
Dashed lines show where additional frame tubes are
installed. If you are not installing any accessories the
accessory framing is not needed.
INSTALL THE END WALL FRAME (continued)
TAPE SHARP EDGES AND CONNECTORS
After the frame is assembled, check the frame for sharp
edges that could damage the cover or end panel, and file
these smooth or tape over them using the supplied duct
tape.
In addition, return to the rafters and apply tape over
each connector to better protect the cover film when it is
installed. The following photo shows one way to apply the
tape.
Rafter and frame shown
may differ from actual frame.
Photo is used to illustrate
how to apply tape.
Duct
tape over
connector
Space below is reserved for customer notes.
