4
Revision date: 11.01.19
CARTS AND WAGONS
Parts List and Tools Required
2
ATTACH STEERING YOKE
STEP 1:
Remove the washer and cotter
pin from the front axle mounting stud.
Press angled front axle brace (installed in
Procedure 1) down and away from axle.
STEP 4:
Install washer and cotter pin. Bend
cotter pin. Use pliers if needed.
STEP 2:
Squeeze yoke ends together and
slide ends between straight and angled
axle braces.
STEP 5:
Take the shoulder bolt, insert it
up through the mounting hole, and add the
flat washer and locknut.
Verify that the shoulder is through all
frame members and tighten the bolt
until the bolt threads extend through
the locking material of the nut. Check
operation. Yoke should move freely.
STEP 3:
Align mounting hole with the
mounting stud and release yoke, allowing
it to snap into place over the mounting
stud.
ATTENTION:
Use the long shoulder bolt
with the longest shoulder. There is only
one bolt with a long shoulder. There are
three (3) bolts with short shoulders.
1/4" (M6) Locknut (1)
1/4" (M6) Washer (1)
1/4" x 1" (M6x22) Long
Shoulder Bolt (1)
Long Shoulder
Socket and Ratchet Set
Pliers
Wrenches
Brace
Steering Yoke
Install mounting stud
through this hole.