FARMTECH T-DCBM-4, User Manual

Page: 10 / 36

11
MAINTENANCE AND REPAIR
ATTENTION!
MAINTENANCE,
REPAIRS, CLEANING MAY ONLY BE
EXECUTED WHEN THE DRIVE AND THE ENGINE ARE
SWITCHED OFF AND THE IGNITION KEY IS PULLED OUT.
Rotary Disc Mower is produced by full of quality.So this machine will not need so much
maintenance and repair after working with the machine.
Take care about the items that is written below for maintenance and repair :
Cleaning, lubrication or adjusting of the implement,driven by the P.T.O shaft can be done
when the connection and the engine are switched off and the ignition key is pulled out.
Maintenance and repair must be done after the shaft and machine is disconnected from the
tractor.
It is easy to repair and make maintenance to the Rotary Disc Mower.
Put the machine in a closed area after work,lubricate the parts and take care against rust.
Control the nuts and screws every day to see if they are tightened enough.If not tighten
them.
Change the broken and weared parts.
Choose the suitable parts while making maintenance.The parts must be safety.
Use adequate tools and gloves during repairs,mainteance and cleaning.
Lubricate the grease nipples periodically as shown in Pic.18-19.
Use original spare parts.
Control the gear box oil level in each 50 hours of work.Change the oil of the gear box after
controlling the oil level in the period of 100 hours work.Use SAE 140 oil in the gear box.Fill 5
litres of SAE140.
If you perform any maintenance on the lifted implement,always secure the implement by a
suitable holder.
Call Türkay technical service for the maintenance of the machine.
Table 7- Maintenance Periods
CONTROL(A) MAINTENANCE(B) VARIATION(C)
Maintenance Period
Daily Weekly
50
hours
100
hours
400
hours
Greasing
(control of transmission oil
level)
Changing of oil (SAE140)
A C
Control of oil leak A
Control of knife corrosion A
Lub. grease nipples B
Control of tightness
(bolt-nut)
A C
Cleaning B