FARMSCAN 30007000-7999, Manual

Page: 5 / 21

4 WWW.FARMSCANAG.COM AM-JACKAL-B / OCT 2018
INSTALLING SENSORS
The following examples will help to determine appropriate sensor input connections into the Jackal.
NB: The Jackal Basic is Unlocked only for Input 1 – Fan or Shaft RPM & Input 2 – Wheel Speed & Area
TWO WIRE “REED” – BLACK END SENSOR WITH MAGNET
KIT # 1007P – WHEEL SENSOR (2 WIRE)
KIT # 2076 – SHAFT SENSOR (2 WIRE)
These kits will all include a “reed” type sensor. The reed type sensor is
a 2-wire sensor (normally black end) and only uses a ground/earth
wire and a signal wire.
•
Insert the black ground wire into (A7) and the white/coloured
signal wire into (A2) for Wheel Input
•
Insert the black ground wire into (A7) and the white/coloured
signal wire into (A1) for Shaft/RPM Input
Use the wizard to setup the port and calibrate the sensor once
installed.
THREE WIRE “PROX” – BLUE END SENSOR
KIT # AA-2010P – WHEEL OR FAN SENSOR (3 WIRE)
These kits will all include a “ square wave ” type sensor. The sensor is 3
wires and uses a ground/earth wire, a signal wire and a 12v power
wire.
•
Insert the black ground wire into (A7) and the white/coloured
signal wire into (A2) for Wheel Input & (B5) for 12v Sensor
Power
•
Insert the black ground wire into (A7) and the white/coloured
signal wire into (A1) for Shaft Input & (B5) for 12v Sensor
Power
Use the wizard to setup the port and calibrate a sensor once installed.
NB: A Proximity sensor can be used for wheel speed or RPM.