Farmi Forest W35R, Operation, Maintenance And Spare Parts Manual

Page: 29 / 42

W35R
29
4. Remove the two bolt s (fig. 19 pos. A) at the upper edge of the cover plate. Socket size 24 mm (15/16”).
5. Remove the drum axle nut (fig. 19 pos. C) and the washer. Socket size 36 mm (1 7/16”)
6. Pull out the winch mechanism. Weight 148 lbs (67 kg).
Fig. 19.
Removing the winch
mechanism
ASSEMBLY OF THE MECHANISM
Make sure that the both pressure bearings are installed in a correct position, that is, the bearing with bigger internal
diameter should be facing the cable drum (figure 21). Make sure that the position of the two clutch engagement
halves is correct (fig. 20).
1. Place one of the clutch engagement halves on the working tble so that the handle is at 8 o’clock position and the
3 slanted surfaces face up.
2. Grease the 3 slanted surfaces with vaseline and place the 3 rollers on the bottom of the slanted surfaces so that the
thin ends point towards the middle. The other clutch engagement half (without handle) has 3 slanted surfaces on
one side and two holes drilled on the other side (fig 20). Two studs on the back of the front plate will fit into these
holes later on when the winch is assembled.
3. Place one clutch engagement half (without the handle) so that the halves bottom out when the handle is at 8
o’clock position and the two holes are at 12 o’clock and 6 o’clock (fig. 20). Be careful, there is only one correct
position! Tape the halves together so that htey will stay together when you mount them on the drum axle.
4. Install a protective plate. Check the clutch adjustment.