Farmhand 70LB, Assembly And Operating Instruction

Page: 3 / 20

3
GENERAL WARNINGS
READ and UNDERSTAND this manual completely before using Push Spreader.
Operator must read and understand all safety and warning information, operating instructions,
maintenance and storage instructions before operating this equipment. Failure to properly operate and
maintain the push spreader could result in serious injury to the operator or bystanders.
Operation Warnings

Do not at any time carry passengers sit or stand on the spreader.

Do not allow children to play on, stand upon or climb in the spreader.

Always inspect the spreader before using to assure it is in good working condition.

Replace or repair damaged or worn parts immediately.

Always check and tighten hardware and assembled parts before operation.

Do not exceed equipment maximum load capacity of 80lb.

Avoid large holes and ditches when transporting loads.

Be careful when operating on steep grades (hill) the spreader may tip over.

Do not push close to creeks, ditches and public highways.

Do not use spreader on windy days when spreading grass seed or herbicides.

Always use caution when loading and unloading spreader.

Never tow the spreader with a motorized vehicle.
.
Crush and Cut Hazards

Always keep hands and feet clear from moving parts while operating the equipment.

Always clear and keep work area clean when operating.

Always
wear safety gear, eye protection, gloves and work boots when operating the spreader.
.
WARNING
The warnings, cautions, and instructions outlined in this instruction manual cannot cover all
possible conditions or situations that may occur. It must be understood by the operator that
common sense and caution are factors which cannot be built into this product and must be
supplied by the operator.
Assembly Is Required
This product requires assembly before use. See “Assembly” section for instructions. Because of the
weight and/or size of the push spreader, it is recommended that another adult be present to assist
with the assembly. INSPECT ALL COMPONENTS closely upon receipt to make sure no components
are missing or damaged.