Manual
VIDIUM P 350 | P 450
17
│
24
Depth
Shear pin
Non-stop
<10 cm
approx. 100 cm
approx. 125 cm
10 cm
approx.100 cm
approx.125 cm
15 cm
approx.103 cm
approx.128 cm
20 cm
approx.106 cm
approx.131 cm
25 cm
approx.110 cm
approx.135 cm
30 cm
approx.113 cm
approx.138 cm
35 cm
approx.116 cm
approx.141 cm
The setting must be selected so that the interior side of the wheels does not collide with the
wall of the furrow.
5.3.3
Setting the Working Depth
In the front part of the plough, the working depth is changed using the three-point hitch of the tractor. Lift
the three-point hitch of the tractor for shallow work and lower it down for deeper work.
The setting of the working depth is changed in the area of the chassis using the setting nuts on both rollers
of the chassis. For that, it is required to lift the chassis so that the setting nuts may be loosen. Turn the
nuts clockwise (in the direction of travel) for shallow work and anti-clockwise for deeper work.
Make sure that the nuts are set to the same depth both on the right and left side, otherwise undesirable
overload will be created in the chassis.
The working depth of the rear plough is changed using the bolts for setting depth on the rear swivelling
supporting wheel. Loosen the safety nuts. Turn the bolts inside for deeper work and outside for shallow
work. Then tighten the safety nuts.
Make sure that both nuts are set to the same depth. Otherwise, the plough will work at different depths on
the right and on the left.
At the beginning, check that the plough is horizontally levelled during work and adjust it using the steps
above.
SETTING THE DEPTH BY THE REGULATION HYDRAULICS:
See the operating manual of the producer of the tractor
S
