8.3.2 Machine Folding Procedure
Machine Folding Procedure – Transport Position
Initial state:
Machine SF4,5–6 PS is unfolded and recessed, both ball valves on the
drawbarare open.
Stroj SF4 P is recessed and ball valve on the drawbar is open.
1
SF4P, SF4,5–6PS
Lift the machine on rollers (or
rollers and drawbar), i. e. extract
the roller piston rods (drawbar) to
limit position, i. e. maximum
extracted position, by means of
the yellow circuit.
SF4P, SF4,5–6PS
Lift the machine to the axle, i. e.
extract the axle piston rods to the
limit position, i. e. maximum
extracted position, by means of
the green circuit.
2
SF4,5–6PS
Unfold the machine using the red
circuit.
3
SF4,5–6PS
Close both ball valves on the
drawbar and then use the yellow
circuit to insert the piston rods of
the side rollers to the end position,
i.e. maximum insertion.
SF4P
Close ball valve on the drawbar
and piston rods of rollers leave
ejected.
SF4,5–6PS
Secure the side frames by the lock
drawbar. Now the machine is
ready for transport.
Warning!!! The machine must only be transported by the axle, not rollers.
25
|
44
