10.1 Adjusting the working depth of the machine
• Setting of soil processing depth is executed on lifted machine through adding or removing of distance
washers on hydraulic cylinders.
• The same number of washers must be set on all
piston rods!!!
•
Transfer ratio between thickness of distance
elements and working depth is approximately 1:3.
•
E. g.: Adding or removing one washer with the
thickness of 3mm (0.12in) changes the working
depth of the machine by 8-9mm (0.32–0.35in).
•
Tab.1 shows the individual working positions and
number of washers needed to achieve the required
machine depth.
•
The position of the tracing wheel for the individual
depths is provided in Tab. 1 in the first column. The
number of the position in the table corresponds
with the number of the opening for the pin on the
tracing wheel arm.
•
Specified working depths at individual positions are
only for information. They may vary according to
particular soil conditions. It is possible to add or
remove a required number of washers as needed.
Tab 1. – Setting of working depth - mm/in
1 – Position of tracing wheel
2 – Number of washers
3 – Working depth
29
|
44
