Manual
KOMPAKTOMAT K500PS | K600PS | K700PS | K800PS | K1000PS
32
│
56
7.
ADJUSTING THE WORKING PARTS OF THE MACHINE
The position of the following individual working parts on the machine can be adjusted
o
Position and depth of the track cultivators
o
Height and down pressure of the front leveller
o
Depth of the shares
o
Position of the leveller behind the shares (only for sweeps)
o
Angle of the rear finishing levelling bar
The control of the front leveller position and the share depth setting can be either mechanical, or
automatic from the driver’s position.
The drawbars of folding can also be adjusted.
7.1
ADJUSTING THE POSITION AND DEPTH OF THE TRACK
CULTIVATORS
The tractor track cultivator position can be adjusted either by height or length, as needed.
When adjusting the track cultivator position, always observe
generally valid labour safety regulations.
Correct position of the track cultivator affects the resulting
quality of processing.
The track cultivators are located on the beams of the pulling
fork. The drawbar beam for attaching track cultivators is
telescopic.
The cultivator can be moved on the beam so that it loosens the compacted tractor wheel tracks
.
Lengthwise setting of the cultivators is performed by releasing the nuts of the screws and moving the
cultivators along the beam into the position behind the tractor wheels so that they loosen the
compacted tractor tracks
.
CULTIVATOR VERSIONS (p. 16)
CA
CC
STANDARD DRAWBAR
BEAM EXTENSION
Min=830mm
Max=1230mm
EXTENDED DRAWBARS
BEAM EXTENSION
Min=1450mm
Max=1790mm
